Rittal 7094100 DK Assembly screws - Phillips-head M6x16, 3 Nm

Phillips-head DK Assembly screws, M6x16 with a 16 mm thread length, are built for 482.6 mm (19-inch) mounting in enclosure systems and backplanes. This geometry supports fast, tool-friendly insertion while maintaining consistent alignment across adjacent components, even in tight 19-inch racks. By standardizing on a single fastener profile, technicians reduce misfits, rework, and confusion during rack assembly and service operations. With a maximum tightening torque of 3 Nm, these screws prevent over-torquing that could strip threads or warp enclosure panels, delivering repeatable clamping force across thousands of installations. The result is improved mechanical reliability, reduced warranty calls, and simpler training for maintenance staff handling 19-inch cabinet assemblies. This makes them particularly suitable for high-density data centers and industrial control rooms where fasteners must perform reliably under vibration and thermal cycling. Plastic washers are included to enhance insulation and provide a modest impedance to loosening caused by vibration, while also minimizing surface damage to galvanized enclosures. The combination of washers and the Phillips-head design yields a clean, flush installation with minimal protrusion, supporting aesthetic and safety requirements in restricted panel spaces. Users benefit from fewer callbacks due to loose hardware and easier inspection during routine audits. Packs of 50 screws streamline procurement and reduce stocking complexity for large projects, while the 12-bit M6 thread and 16 mm length ensure compatibility with a wide range of Rittal enclosures and 19-inch accessory components. The product's ETIM EC000889 and ECLASS 8.0 23110190 classifications support data-rich catalogs, ERP integration, and supplier diversity programs. With EAN 4028177663015 and the explicit product description, sourcing and specification tasks become faster and more accurate for procurement teams.